The Simrad 3G Broadband Radar Dome is ideal for sailboats that want to save power or boats at anchor who don't want to run the radar continously.
Broadband 3G™ Radar allows you to see more targets farther away from your boat. Now you get the same impressive short-range capabilities of the original Broadband Radar™ with the addition of exposing targets previously unseen before.
Unparalleled Short Range Target Discrimination - Where it Matters Most
Simrad Yachting's Broadband Radar™ provides amazing target resolution, even at an unprecedented 1/32 nm range. Docks, channel markers, moored vessels and other critical targets are displayed with clarity and separation, for added confi dence in close quarters. Broadband Radar™ technology also eliminates the "main bang" of a pulse radar - the obscured "dead zone" immediately around the vessel - which interferes with close target detection.
Lowest RF Transmission for Safe, Flexible Installation
Because Simrad Broadband Radar™ transmits at 1/10,000 the power of typical pulse radars (emitting 5 times less energy than an average cell phone), the radome is safe to mount in locations never before possible. In addition, the lowest DC power draw of any X-band marine radar makes this system ideally suited for sailboats and other vessels with limited power.
Navigation in an Instant
No more waiting 2-3 minutes for a magnetron to warm up - 100% solid-state design provides InstantOn™ capability. When darkness falls or the fog rolls in, you will always be ready. Ideal for sailboats wishing to save power, or boats at anchor not wishing to run the radar continuously.
Antenna Beam Width Horizontal 5.2°+/-10% (-3dB width) °
Antenna Beam Width Vertical 25°+/-20% (-3dB width) °
Antenna Receiver Noise Figure 6 dB
Antenna Rotation Speed 24/36 rpm +/- 10% RPMs
Radar Warm Up Time 0 min
Radar Wind Resistance 51 m/sec (Max:100 Knots)
Transmitter Frequency X-band - 9.3 to 9.4Ghz
Transmitter Power Output 165mW nominal
Data I/O Protocol High Speed Ethernet
TECHNICAL / ENVIRONMENTAL
Mounting Bolts: 4x30xM8 - 304 stainless steel
Waterproof Standard IPX6
Height 280 mm \ 11 in
Diameter 488 mm \ 19.2 in
Weight 7.4 kg \ 16.31 lbs
Humidity +35°C (95xF) 95% RH
Power Supply 9V to 31.2Vdc (12/24 Volt systems) Reverse polarity protection vDC
Power Consumption 18W (Typ.) @ 13.8Vdc
Power Consumption Standby 2W (Typ.) @ 13.8Vdc - only 150ma
Compliance CE, FCC (ID: RAY3G4G), IC: 4697A-3G4G
Interconnection Cable 10m (33ft) standard with RJ45 thin custom (Max 30m)
Interface Heading SimNet or NMEA 0183 with cable kit into display
Operating Temperature -25° to +55°C (-13° to +130°F)
|Image||Part #||Product Description||Price||Stock||Order|
|000-10420-001||3G broadband radar dome for NSE, NSO and NSS series||
Thinking of hitting the ice with a SondeCAM underwater fishing camera? Due to its rugged design, you won't have to worry about it handling the harsh elements. However there are a few simple tricks to get the most out of a FishSens SondeCAM while ice fishing. You won't have to do anything to modify the SondeCAM itself, but you are going to have to bring a few extra things. Most importantly we are going to need a power source. Unless you are hauling your gear with a truck, you'll want something more portable than the battery you used in the boat. Pick up an inexpensive and maintenance-free 12-volt, 9-amp battery. It is going to provide plenty of power, but will be much lighter and take up less space.Read More
We've all felt the frustration of weeding through a school of dinks to catch a "keeper." Often the small fish outnumber the bigger ones and they are typically more aggressive. Sometimes there's no choice but to deal with it, as is often the case with open water fishing. However a frozen lake involves a vertical presentation and a stable platform, it's a perfect situation to pick and choose which fish you want. Once you locate a school and get set up it's time to start sizing them up with a FishSens SondeCAM underwater fishing camera. It can be mind-blowing just how big some of these schools of fish are and also how outnumbered fish of a desirable size can be.Read More
It’s no secret that anglers have been the means by which invasive species and non-native fish have spread to new water bodies in the past. Fishermen have even been known to transport some of their favorite fish to new areas on purpose so that they can catch them a little closer to home. And the results of those actions have not always been ideal. In Ontario, Canada, fishermen have taken non-native bass and stocked them into what were historically lakes dominated by brook and cutthroat trout. The actions have impacted ecosystems, but scientists have been unable to broadly study the effects because they didn’t have enough data. But that is no longer the case for some Ontario lakes, as a study from biologists at the University of Toronto shows.Read More